Messages

2141

General Mach Discussion / Re: Mach 3 SDK ?

« on: October 01, 2006, 08:18:44 AM »

C# ... nope it is C++ and needs to be VC2003   The Free 2005 will not work

2142

General Mach Discussion / Re: encoders practical uses with steppers?

« on: October 01, 2006, 08:16:20 AM »

Brian what was the board that Ron was selling for monitoring or controlling? and which  Ron ?
Thanks Bob

It is for monitoring only

2143

General Mach Discussion / Re: loop function doesn't work properly

« on: October 01, 2006, 08:13:53 AM »

Is this still a problem in the latest version? If so we will have a look at it


Thanks
Brian

2144

General Mach Discussion / Re: Event Driven Serial Control

« on: October 01, 2006, 08:11:34 AM »

I think the best thing to do is to look at the Plug In for the G100 and have a look at how the data is passed to it. THere is a Doc that Art did that tell how it works It is all on the downloads page.

Thanks
Brian

2145

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 29, 2006, 09:36:08 AM »

http://www.hobbycnc.com/hcncpro.php

I have never used them my self but many others have

2146

General Mach Discussion / Re: Mach III and Gecko 201s Problem - HELP !

« on: September 28, 2006, 09:19:18 PM »

Do you have backlash turned on?

2147

General Mach Discussion / Re: Need limit switch help

« on: September 28, 2006, 09:16:48 PM »

Yup That is how the the old mill I had worked... you are very good to figure that out!

2148

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 28, 2006, 09:15:08 PM »

There are some low cost drivers that will give you all 3 axis for about 130.00 I think Woudl that work for you?

2149

General Mach Discussion / Re: Standard Configurations

« on: September 28, 2006, 09:12:51 PM »

THere is with some of the breakout boards.. if you get one of bob's boards it will tell you what to hook to every pin. Other then that you can hook up about any way you like

2150

General Mach Discussion / Re: encoders practical uses with steppers?

« on: September 28, 2006, 09:10:48 PM »

Ron was selling a board to do that ...