591
Galil / Re: Is it true about Galil plugin?
« on: July 11, 2008, 10:57:43 PM »
Hello,
You should be able to have both controllers on the same machine (I have seen it work in the past ). So the question is , what in the heck is going on!.. Could you please do a few test for me and we will see if you have settings that are in your Galil but are not burned into the eprom. Please power down for a minimum of 5 min and restart the system Try to run mach3 and do some MDI moves. Now shutdown Mach3 and start Camsoft and then close Camsoft. Run mach3 again (do not restart the computer) Will to run now? if so that may be a mode being set in the Galil...
Now one more thing, what do you have for a Galil? By any chance would this happen to be a 21XX ethernet board
Thanks
Brian
You should be able to have both controllers on the same machine (I have seen it work in the past ). So the question is , what in the heck is going on!.. Could you please do a few test for me and we will see if you have settings that are in your Galil but are not burned into the eprom. Please power down for a minimum of 5 min and restart the system Try to run mach3 and do some MDI moves. Now shutdown Mach3 and start Camsoft and then close Camsoft. Run mach3 again (do not restart the computer) Will to run now? if so that may be a mode being set in the Galil...
Now one more thing, what do you have for a Galil? By any chance would this happen to be a 21XX ethernet board
Thanks
Brian