Messages

2231

General Mach Discussion / Re: Hesatation? after arc move

« on: September 13, 2006, 07:01:37 PM »

Try putting a G64 in the Gcode program

How is it then?

2232

General Mach Discussion / Re: Digitizing ????

« on: September 13, 2006, 07:00:04 PM »

There is also a plug in used to probe with.. the plug in is MANY times faster at getting the points...

It is on the downloads page

2233

General Mach Discussion / Re: OEM Mach 3

« on: September 13, 2006, 06:58:01 PM »

If you are going to build and sell tables Mail me off list and I will get you setup as an OEM

2234

General Mach Discussion / Re: About this forum

« on: September 13, 2006, 06:55:42 PM »

What, no question

Thanks
Brian

2235

General Mach Discussion / Re: Can you stop release on outside jogging

« on: September 13, 2006, 06:53:45 PM »

Great it is nice to keep people happy

2236

LazyCam (Beta) / Re: Tool dia, where is it taken into account?

« on: September 12, 2006, 11:58:54 AM »

At this point you shoud do it in your Cad software but that will cahange after I finish the Offset path in Lcam

2237

LazyCam (Beta) / Re: LAzycam and THC300

« on: September 12, 2006, 11:57:43 AM »

It is in Lcam now

2238

General Mach Discussion / Re: Is there an OEM code for CCW spindle?

« on: September 12, 2006, 11:32:10 AM »

All you need to do is put DoSpinForward() and so on... you can see the calls in the m3-4-5 macros as for the LED's I think there are OEM numbers for them in mach 3...

I will look..

164 and 165 should get you the LED's that you need

2239

General Mach Discussion / Re: Installation problems - No Driver Sensed Installed. Run Driver Test

« on: September 12, 2006, 11:24:23 AM »

Are you un checking the Install Driver at the end of the install?

2240

General Mach Discussion / Re: No movement

« on: September 12, 2006, 11:21:22 AM »

There are docs for the pinout on the FTP server I will see if I can get an XML from a guy that I helpped out that other day and post it on the FTP server