Messages

3131

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: April 25, 2006, 06:45:31 AM »

Where did you place the macropump.m1s file? Did you turn it on under Config/State? If that checks out okay Post your XML and I will see if there is a setting that you need to have set.

Thanks
Brian

3132

General Mach Discussion / Re: MOTOR LOCK-UP ON RAPID MOVEMENT

« on: April 25, 2006, 06:40:58 AM »

taking it down to 25KHz will take a little stress of the computer... If you don't need it up that high then why not Please be sure to set the step to 5us long.
Thanks
Brian

Bryan, I will give your suggestion a try in the morning.  Can you explain how kernel speed cause a motor to stall?  I appreciate all your input.

Steve

3133

General Mach Discussion / Re: rapid travel problem

« on: April 24, 2006, 09:57:39 PM »

It will show it going faster in the angle move... 45 will be the fastest Speed = ( 40^2 + 40^2 ) ^.5  = 56.57 IPM in a 45 Deg move.
As you can see each axis is doing only 4o IPM.
Hope that helps
Brian

3134

General Mach Discussion / Re: Asigning a 4th linear axis ?

« on: April 24, 2006, 06:43:14 PM »

I would set it up as the C axis... and you should be good to go...

3135

General Mach Discussion / Re: MOTOR LOCK-UP ON RAPID MOVEMENT

« on: April 24, 2006, 06:41:37 PM »

OKay try running the system at 25KHz and set you step to 5us under the motor tuning. If you have trouble with this please post you your XML and I can do it for you.

3136

General Mach Discussion / Re: What are min PC requirements for Mach

« on: April 24, 2006, 06:24:32 PM »

No problem. and sorry for the confusion

3137

General Mach Discussion / Re: Inch and mm

« on: April 24, 2006, 05:22:20 PM »

Look at G20 and G21.. G20 is inch and G21 is mm

3138

Show"N"Tell ( Your Machines) / Re: Got My mill running :)

« on: April 24, 2006, 02:32:37 PM »

I have tested that and I can't seem to get it... I did run a lefthanded bit into some AL at 12000 Rpm... Art was there forthat one and still no blue. I will keep working on this problem

3139

General Mach Discussion / Re: What are min PC requirements for Mach

« on: April 24, 2006, 02:28:23 PM »

I was trying to get you to fish for the info NOT make you upset Sorry about that... Here are the links that I got from the forum search:

http://machsupport.com/forum/index.php?topic=478.0 if you type computer

http://machsupport.com/forum/index.php?topic=391.0 if you type Requirements

Sorry for not posting the info but I knew that it was going to take me a few hours before I would have time to go look the stuff up for you and knew you could get it in a few min if you used the search... Have a nice day and I am here to help.

3140

General Mach Discussion / Re: MOTOR LOCK-UP ON RAPID MOVEMENT

« on: April 24, 2006, 01:57:44 PM »

That looks good...