Messages

1331

General Mach Discussion / Re: License Installing problem

« on: April 06, 2007, 06:12:31 PM »

Please mail me a copy of your license file and I will test it here with the License file generator.

Thanks
Brian

1332

General Mach Discussion / Re: Set Z to zero automatically?Auto tool zero questions

« on: April 06, 2007, 05:05:26 PM »

Could you try testing it with the X axis unslaved?

1333

General Mach Discussion / Re: Wrong working with Mach3.

« on: April 06, 2007, 05:01:42 PM »

Also after you are done the run move back to X0.0 Y0.0 and see if you are on position

1334

General Mach Discussion / Re: slow motion if firefox is active

« on: April 06, 2007, 02:56:52 PM »

I see, so you are researching for the next "part" that you are going to cut... You multitasker!

1335

General Mach Discussion / Re: slow motion if firefox is active

« on: April 06, 2007, 02:14:44 PM »

Stop surfing the web when you are cutting

The problem is the we are using 50% of the CPU for motion and FireFox needs more

1336

General Mach Discussion / Re: servo following error problems

« on: April 06, 2007, 02:09:12 PM »

Do you have a Scope to look at the pules? I think you have a noise problem

1337

General Mach Discussion / Re: Macropump help

« on: April 06, 2007, 02:07:39 PM »

You should not jog the axis from VB.. if you need an input to Jog the machine please use the Jog inputs under inputs on the ports and pins page


Thanks
Brian

1338

General Mach Discussion / Re: Wrong working with Mach3.

« on: April 06, 2007, 02:04:41 PM »

It looks to me like you have lost steps... try sherline mode and see if you have the same problem

Thanks
Brian

1339

General Mach Discussion / Re: Output issue

« on: April 06, 2007, 01:59:46 PM »

Sounds to me like you have a prots and pins settings that are not right OR you have a bad pin

1340

General Mach Discussion / Re: License Installing problem

« on: April 06, 2007, 01:43:01 PM »

Did you install it in the C://Mach3 Directory?