Messages

3181

Show"N"Tell ( Your Machines) / Re: Got My mill running :)

« on: April 20, 2006, 02:06:30 PM »

I made my own cables... the breakout is to big and nasty to put in my mill

3182

General Mach Discussion / Re: mach2 and G76

« on: April 19, 2006, 09:51:21 PM »

I am going to look a bit more and see if I have done somthing wrong...

3183

Show"N"Tell ( Your Machines) / Re: Got My mill running :)

« on: April 19, 2006, 09:35:50 PM »

Yes they are 

3184

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: April 19, 2006, 09:31:25 PM »

Thank you for the file! I will have a look at it.

3185

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: April 19, 2006, 09:30:12 PM »

I have (in the past) redone the buttions for the FRO... I have made buttons that will not go past 125% because I program with the right rate and don't ever need more than 125%... If you would like I can give you a hand with that.

3186

General Mach Discussion / Re: mach2 and G76

« on: April 19, 2006, 09:27:21 PM »

That is odd.. It should be working..

3187

Mach Screens / Re: Screen design basics (Using Screen4)

« on: April 19, 2006, 08:17:22 AM »

Well All I can say is sorry I don't use Screen 4... If you need a hand running Mach I am there

3188

General Mach Discussion / Re: Verticle borer/lathe retrofit

« on: April 19, 2006, 08:13:50 AM »

You should be Okay but there are many things that you are going to have to do to get it running you will have to put a prox on the spindle so you know when to start the thread and you are going to have to put on the servo's... Other than that it should be no problem.

3189

General Mach Discussion / Re: Problem with extra Parrallelports

« on: April 19, 2006, 08:10:58 AM »

IT should work .... I have not tested that becuase I am running my spindle with a PLC

3190

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: April 19, 2006, 08:09:13 AM »

If it was me I would have it set to 100IPM for the max rate...