Messages

2041

General Mach Discussion / Re: What Have I done?

« on: November 05, 2006, 05:27:23 PM »

I am getting an Abnormal flashing button with a comment about "Axis are not refed to normal condition". Somehow I started this and now can't figure out how to correct the problem. OK, I am not sure what it means or what I did to cause it.

Can anyone help?

Jim

If this is still the problem... all you need to do is set up your machine so that it is ready to run and double click on the "Normal Condition" and it will set that state to be the normal run condition of your machine that is all it is..

2042

General Mach Discussion / Re: Error Triggered -- Art Code 1 & 9991

« on: November 05, 2006, 05:19:21 PM »

There was a problem with the bitmap buttons that could have caused the problem that you have. when the new version is out please test it and see if it helps.

If not send me the macro pump code and I will test it here.

2043

General Mach Discussion / Re: z height self reset

« on: November 02, 2006, 09:11:00 PM »

Do you have an external  button that will set the Zheight?

2044

General Mach Discussion / Re: New Fixture save

« on: November 02, 2006, 09:09:53 PM »

That seem to be giving Art a hard time but I think it is getting better all the time 

2045

General Mach Discussion / Re: modbus for encoder input?

« on: November 02, 2006, 09:07:04 PM »

as long as you don't need to know the position real time it should be okay...

2046

General Mach Discussion / Re: New Fixture save

« on: November 01, 2006, 09:28:06 PM »

That is why we added the test to see if it was going to hit before you run the file

2047

General Mach Discussion / Re: A axis and Mach3R2.0.005

« on: November 01, 2006, 09:25:26 PM »

That is going to be a very hard one to find

2048

General Mach Discussion / Re: MAch 4 Grex

« on: October 31, 2006, 04:11:39 PM »

I would not do it at this point But give it about 8 weeks and I think we may have something

2049

General Mach Discussion / Re: Beginner needs help W/ Mach 2 Mill

« on: October 30, 2006, 10:48:21 AM »

open the box and see what is in it

2050

General Mach Discussion / Re: Beginner needs help W/ Mach 2 Mill

« on: October 30, 2006, 09:48:10 AM »

You need to know what you have for heardware to set the settings