Messages

2021

General Mach Discussion / Re: setting guage block height

« on: November 10, 2006, 05:57:13 PM »

Press enter after

2022

Galil / Re: Mach3 + Galil

« on: November 10, 2006, 05:35:22 PM »

What I am thinking about doing will work for any Card that you have (even the Printer port)

2023

Galil / Re: Mach3 + Galil

« on: November 09, 2006, 02:14:32 PM »

So I have run the Galil on the large mill under mach3 there are little problems but for the most part it is working very well! I Have it doing CV at about 400IPM on a mill that is 40,000 LB I have a video that I will send to Benny to convert to something that you all can read. WE have to get IO finished, homing, toolchanger and spindle. I would like to make it so that others can do there own toolchangers by making a new Toolchange plug in that you can just type the I/O in the order that it needs to happen... There will be more to come when I get to it


Thanks
Brian

2024

LazyCam (Beta) / Re: DXF import fails everytime and gives illegal argument error.

« on: November 09, 2006, 02:06:50 PM »

That is odd ... I will have to try that.

2025

VB and the development of wizards / Re: turning an ellipse wizard needed

« on: November 09, 2006, 02:05:41 PM »

O boy that is not as simple as it sounds

I think that Cam is going to be the only way to get that ...

2026

General Mach Discussion / Re: Tangential control

« on: November 09, 2006, 02:03:39 PM »

Should work... I can make a post for Lcam that will output the moves for the A axis as well

2027

General Mach Discussion / Re: Mach to DeskCNC?

« on: November 09, 2006, 02:01:32 PM »

The same old thing Firmware ;(

2028

General Mach Discussion / Re: Fast Z on 2.5D machine

« on: November 09, 2006, 01:59:17 PM »

So did it work for you

2029

General Mach Discussion / Re: Fast Z on 2.5D machine

« on: November 08, 2006, 07:15:25 AM »

It works here (after I took the time to hook the test rig up again ) You need to have the E number one less then the output that you would like to run SO if you would like to turn on and off external output #4 Use "E3 P1" and "E3 P0" .

Thanks
Brian

2030

General Mach Discussion / Re: Des Plaines, IL Needs Help With Mach 3 and Control Box

« on: November 08, 2006, 07:01:59 AM »

Did you get some help?