Messages

2721

General Mach Discussion / Re: Help Using Mach 3...

« on: June 23, 2006, 10:01:03 PM »

This should get your router running... This is only the first shot so give it a try and tell me how it works out. You are going to need the newest version of mach3

2722

General Mach Discussion / Re: parallel port pinout

« on: June 23, 2006, 05:48:58 PM »

You may not need Step - and Dir - ... Check the drive data for "Open end Connection"

2723

General Mach Discussion / Re: Using a stepper as a spindle motor

« on: June 23, 2006, 05:47:26 PM »

It didn't do the right speed because it didn't know the ratio to use. (just a thought)

2724

General Mach Discussion / Re: Help Using Mach 3...

« on: June 23, 2006, 05:44:18 PM »

There is a file named Mach3Mill.XML . It is in the Mach3 directory

2725

Show"N"Tell ( Your Machines) / Re: router retrofited

« on: June 23, 2006, 12:43:38 PM »

This is not off topic Thank you and it is nice to know that there are people like you out there like you! (I may have a few Galil questions for you )


If there is anything that I can do to help you please feel free

Brian

2726

General Mach Discussion / Re: Help Using Mach 3...

« on: June 23, 2006, 12:40:27 PM »

Post your Mach2 XML and I will convert it when I have sometime

2727

General Mach Discussion / Re: Using a stepper as a spindle motor

« on: June 23, 2006, 12:07:49 PM »

under the motor tuning change the step per unit I think it is going to be about 96000 ..

2728

Tutorials / Re: G-Rex setup guide for new users

« on: June 23, 2006, 09:05:49 AM »

You need to load the firmware   (I think)

2729

Show"N"Tell ( Your Machines) / Re: router retrofited

« on: June 23, 2006, 09:04:26 AM »

What are you using for Galil ? Are you writing your own App to run the Galil? We are looking to support Galil is why I am asking

2730

General Mach Discussion / Re: 50 in/min but no faster

« on: June 23, 2006, 08:59:48 AM »

half the accel as a test..
Thanks