Messages

1581

General Mach Discussion / Re: Strange Behaviour

« on: February 11, 2007, 10:06:21 AM »

Are you running any feed override? try setting the FRO to about 90% and tell me if that makes it happen.

Could you please post the 2 G code lines that will make this happen? I will see if you are getting an over accel.

1582

General Mach Discussion / Re: motors gone mad with new computer

« on: February 11, 2007, 10:02:22 AM »

are you running a breakout board? I think you may be seeing a 3.5V Pport

1583

General Mach Discussion / Re: Driver poblems

« on: February 11, 2007, 09:57:35 AM »

Check the cable and be sure you don't have a 25 pin Serial cable

1584

General Mach Discussion / Re: A little more help needed

« on: February 11, 2007, 09:23:09 AM »

Gerry is right! offsetting in DXF is a much better way to go... Cutter comp is not as simple as it sounds

1585

General Mach Discussion / Re: thc help

« on: February 11, 2007, 09:11:01 AM »

I would update the software

1586

General Mach Discussion / Re: thc help

« on: February 08, 2007, 09:37:03 AM »

I have a THC on the Plasma that I run and you are right! I never use it on the thick stuff. I built my own THC and added code  so I could turn it off and run the head with an Up/Dn button. You will need to contact the one that made the unit that you are running (sorry I have never use that one) and see how to trun it off. Also ask them if there is a way that you can move the Z during the cut

your should be okay at 35 KHz, you just need to set the THE corection speed DRO to a lower value. Hope that helps
Brian

1587

Newfangled Solutions Mach3 Wizards / Re: Circular pocket question

« on: February 07, 2007, 06:16:56 PM »

Ron is a Great guy and I think everyone is going to be much happier with him working on the Wizard set!

1588

LazyCam (Beta) / Re: importing jpg bmp to lazycam

« on: February 07, 2007, 06:13:23 PM »

I think you need to have more Ram

1589

LazyCam (Beta) / Re: Thanks to Brian & or Lazy cam Team! Please keep up the good work!!!

« on: February 07, 2007, 06:12:16 PM »

We are thinking about that but we need more time

1590

LazyCam (Beta) / Re: relocating x0 y0 start position

« on: February 07, 2007, 06:10:53 PM »

Can you update your video drivers? There is something that you computers video can't do