Messages

3531

General Mach Discussion / Re: Y axis stalling

« on: February 06, 2006, 04:17:40 PM »

Is this a stepper machine? if so try turning down your acceleration

3532

General Mach Discussion / Re: Y axis stalling

« on: February 06, 2006, 03:42:04 PM »

What are you running the feed over ride at?? 

3533

Newfangled Solutions Mach3 Wizards / Re: How to get Wizards?

« on: February 06, 2006, 03:43:59 AM »

You should have it now

3534

G-Code, CAD, and CAM discussions / Re: G71, G70 roughing, finishing lathe

« on: February 06, 2006, 03:41:16 AM »

At this point Cam is the best way to go...

3535

General Mach Discussion / Re: DRO as encoder?

« on: February 06, 2006, 03:39:13 AM »

IF you hook them up you will not be able to turn them to fast as the computer is only running a 25 - 45 KHz. Hope that helps

3536

General Mach Discussion / Re: Newbie!!!! ( Need G-code help)

« on: February 06, 2006, 03:36:01 AM »

It looks like you make code from a layer that had nothing on it...

3537

G-Code, CAD, and CAM discussions / Re: G84 Canned RH Tapping Cycle

« on: February 05, 2006, 03:33:45 PM »

I think I can get it to work I am in hopes that Art may add in the code for the G74 and G84... after that I think we are going to have a nice wizard!

3538

Newfangled Solutions Mach3 Wizards / Re: How to get Wizards?

« on: February 05, 2006, 07:34:42 AM »

Sorry, you used the Email address that you are using here:)

I just checked and Scott sent you a license file 27min after we got the request. If you didn't get it I will resend it to you.

Thank you
Brian

3539

Newfangled Solutions Mach3 Wizards / Re: How to get Wizards?

« on: February 05, 2006, 07:29:30 AM »

Sorry about that, coul you send me an E-Mail with the Address that you have your paypal set up with.
Thank you and have a great day
Brian

3540

General Mach Discussion / Re: Mach 3 problem

« on: February 05, 2006, 07:23:50 AM »

On the settings page there is a button to OVER RIDE LIMITS. press this button, reset the control and jog off the limit.

That should do it:)