Messages

3071

General Mach Discussion / Re: plasma floating z zero offset

« on: May 02, 2006, 10:50:02 PM »

Positive I think...

3072

Mach3 and G-Rex / Re: Mach IV Tool Offset

« on: May 02, 2006, 08:08:52 PM »

That may not be turned on the the software... I will forward that off to Art.

3073

General Mach Discussion / Re: Missing Steps

« on: May 02, 2006, 08:07:54 PM »

Put in a pulse width of 5us that could help it...

3074

General Mach Discussion / Re: Feed Rate Errors

« on: May 02, 2006, 08:06:34 PM »

That is the CV (G64) try putting it in Exact stop (G61)

3075

Mach3 and G-Rex / Re: Mach 4, G-Rex and linear encoders...

« on: May 02, 2006, 06:42:53 PM »

That part of the firmware has not been writen into the G100. I don't know when Steve H. will start to code that in.

Thank you
Brian

3076

General Mach Discussion / Re: plasma floating z zero offset

« on: May 02, 2006, 06:39:17 PM »

You should put it in here... under the home off in the Z

3077

G-Code, CAD, and CAM discussions / Re: Peculiar Z movement

« on: May 02, 2006, 01:15:31 PM »

yes put the G43 H1 on line 70

3078

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: May 02, 2006, 11:51:22 AM »

I think I have that problem fixed in the Rev that I have ... I will check it out.

Thanks
Brian

3079

General Mach Discussion / Re: Pacific Scientific Drives

« on: May 02, 2006, 11:49:22 AM »

In the past i have used : http://www.usdigital.com/products/ea/   EA-D10 with the W5 Opt.

That should get you up and running!

3080

General Mach Discussion / Re: Spindle speed measuring

« on: May 02, 2006, 10:05:06 AM »

http://web5.automationdirect.com/adc/Shopping/Catalog/Sensors_-z-_Encoders/Inductive_Proximity_Sensors/12mm_Round_(AM-z-VM1-z-PMW_Series)/Standard_Sensing_Distance_(AM1_Series)/AM1-A0-1A
Check that out...