Messages

1871

VB and the development of wizards / Re: ActivateSignal(OUTPUT1)

« on: December 15, 2006, 08:07:00 AM »

No problem! Nice to see that you fixed it 

1872

General Mach Discussion / Re: Change speed and zero fifth axis

« on: December 15, 2006, 08:03:45 AM »

You will need to aet up a 5axs screen set... check out the screen design section of the forum.

and the speed is a mix of Deg per min and In per min... If you look on the net there are a few places that talk about how to do that It is not a simple thing to do and most Cam systems should put out code to take care of that.

Thanks
Brian

1873

General Mach Discussion / Re: Mach3 thinks it's moving Z from THC but Torch height unchanged

« on: December 15, 2006, 08:00:34 AM »

Set the rate to correct the axis at a low number to start with and see if it works..
Thanks

1874

General Mach Discussion / Re: Rotary Axis Problems

« on: December 15, 2006, 07:58:05 AM »

Art has been working on this problem and had done something in the last iteration... I will have to get into it and have a look... please if you can post a two or three line program that is not working well on your machine and I will have a look at it.
Thanks

1875

General Mach Discussion / Re: onwers manual

« on: December 15, 2006, 07:50:53 AM »

I get stuff like that from:
www.jameco.com/

1876

General Mach Discussion / Re: I'am new on your site......and a total beginner...

« on: December 15, 2006, 07:48:53 AM »

You should be able to write code in the wizards that are free to cut simple features... What are you looking to do?

1877

Tangent Corner / Re: New cnc project

« on: December 11, 2006, 08:58:55 AM »

I would like to have that to start a campfire

1878

General Mach Discussion / Re: Feedrate Overide Ver 2.25 3 Issues maybe??

« on: December 11, 2006, 08:55:30 AM »

1. Us No FOR On Q in the settings page and that will stop that problem.. The problem is more complex then you think

2. This should have been fixed in this version... Art has been putting time into that section of code and I have told him about your experience

3. Nope, this is a problem with CV The planner is working in the future and you are seeing where the planner is setting the new feedrate. This can be fixed on the external movement devices but not for the printer port Once again we are looking into making this better but it is no simple task.

1879

General Mach Discussion / Re: Version .025 is online

« on: December 11, 2006, 08:46:00 AM »

As you can tell it is going to be a big year next year This years sales (so far) are 3050 new License files! We hope to do that again with the added enhancements..

1880

General Mach Discussion / Re: Automatic tool changer

« on: December 11, 2006, 08:43:50 AM »

Thank you Fernando , spot on