Messages

2561

LazyCam (Beta) / Re: New problem

« on: July 16, 2006, 10:54:40 AM »

I think there is a problem with the Comp (G42 or G41) that is getting called This is not a simple problem and will take some time to fix.
Thank you
Brian

2562

G-Code, CAD, and CAM discussions / Re: G31 again

« on: July 16, 2006, 10:52:56 AM »

Try to put in a debounce of 1000. You may be reading noise...

2563

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 16, 2006, 10:51:07 AM »

What do you get when you run a driver test?

2564

General Mach Discussion / Re: Lap Top

« on: July 16, 2006, 10:48:59 AM »

The one that I used did not work I think there are others out there that have had better luck...

2565

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 15, 2006, 05:16:23 PM »

I think you need to do some optimization... There is a link for it on the Mach Support page here :
http://www.machsupport.com/optimisation%20XP.txt

2566

General Mach Discussion / Re: Suggestion

« on: July 15, 2006, 12:51:42 PM »

I change the code in the button to :

Code "G00 G53 Z-.1"
Code"X0.0 Y0.0"

2567

General Mach Discussion / Re: Just full of requests today

« on: July 15, 2006, 12:50:02 PM »

press the Tab button and you should have all the settings

2568

LazyCam (Beta) / Re: New problem

« on: July 15, 2006, 12:49:05 PM »

will it work if you change the G41 to a 42?

2569

LazyCam (Beta) / Re: Reverse import of hole into LZ

« on: July 15, 2006, 12:47:29 PM »

That is some code that Art did... I will have him look at it when he gets back on two weeks

Thank you
Brian

2570

LazyCam (Beta) / Re: HPGL Import

« on: July 14, 2006, 10:18:45 PM »

I will take a look at it