Messages

1801

General Mach Discussion / Re: Stepper iregular or stalling in MDI or program run

« on: December 30, 2006, 05:52:24 PM »

Tun off everything under MSconfig/startup as well. There coudl be a program that is getting loaded that is the problem. Also you need to look for power settings on your computer. Laptops change the CPU speed to save battery life and that is Not so good for mach3 as it needs to have everything running at the right time (speed)

1802

General Mach Discussion / Re: G81 Question

« on: December 30, 2006, 05:49:41 PM »

Looks like you are all set now

(Look at G98 and G99 for more info on how the R is used)

1803

General Mach Discussion / Re: Small hobby CNC routers

« on: December 30, 2006, 05:48:33 PM »

Use Mach3

I can't setup mach2 anymore

1804

VB and the development of wizards / Re: Available serial commands?

« on: December 30, 2006, 10:40:37 AM »

If you set up to run over modbus you can do it

1805

General Mach Discussion / Re: G81 Question

« on: December 30, 2006, 10:39:08 AM »

Z is the depth of the hole and R is the distance that you would like to rapid too.. R must be greater then Z

1806

General Mach Discussion / Re: still having trouble with Arc Radius and cutter radius

« on: December 30, 2006, 10:09:24 AM »

Can't do that in notepad you can tell it to goto a line number and that will be the same as thing numbering in Mach3.
I never use line numbers in my programs, I think that they are useless and only make the program bigger

that is just me...

1807

General Mach Discussion / Re: Rotary and linear axis not moving together in automatic mode.

« on: December 30, 2006, 10:06:54 AM »

Will be changed in the next release

1808

General Mach Discussion / Re: still having trouble with Arc Radius and cutter radius

« on: December 30, 2006, 08:35:39 AM »

Post an example Gcode file and I will see if we can get you running

1809

General Mach Discussion / Re: motor setup

« on: December 30, 2006, 08:34:15 AM »

What mode are you running in? 25KHz?

The desktop computer would give you less trouble

1810

General Mach Discussion / Re: Rotary and linear axis not moving together in automatic mode.

« on: December 30, 2006, 08:30:17 AM »

It will not move at the same time because the movement for the simultaneous is not supported. I am going to look in the code and see if it can be changed