Hello DWalsh62,
If you can find what you are looking for by decompiling the code go for it! The trouble is that it is not going to help you.. There is NO setting for the pull off amount. I will tell you how homing works and then I will tell you about what is going on with your system.
How it works:
1.) Machine starts by doing a move looking for the home switch
2.) Switch is found and motor decelerates (based on the motor tuning settings)
3.) Motor reverses looking for the switch to open back up at 20% of the home speed (this is what you are calling the pull off move)
4.) Switch opens back up and the motor decelerates
5.) Axis machine position is set to zero
As you can see I never said anything about pull off distance because there is none..
What could be your issue (this is after working on problems like this for over 10 years) :
Electrical noise... How do you know that is what it is .. well I think you are telling me that it is not pulling off the home switch. On the diagnostics page please tell me if the home switch is still active after the homing is done. If the machine is on the switch you need to add some debounce to the inputs. This can be found under config general config, I would start with about 500 and see if that helps.
Now as far as you thinking that we are not responding ... I could see that there where people looking at your post as soon as you put it up.. ALSO we have full time support staff to see that if you contact us you will get taken care of in a reasonable time. I don't see the need for being so nasty, it is okay because I forgive you
I know it can be frustrating when setting up a machine and you need to get parts done and you are dealing with software issues. Best of luck and if you need help please feel free to contact me directly.
Thanks
Brian