Messages

2531

General Mach Discussion / Sorry I am out

« on: July 21, 2006, 10:50:32 PM »

Hello All, My wife and I are about to have our first baby  I will be out for a few days but will be back to help on the forum as soon as it is all over...


Thank you and sorry I have not been around
Brian

2532

General Mach Discussion / Re: need help

« on: July 19, 2006, 10:43:30 PM »

Is there someone that can give us an XML for a campbell break out board?? Thank you!
Brian

2533

General Mach Discussion / Re: Mach + Grex + Pendant w/MPG

« on: July 19, 2006, 10:41:34 PM »

It should be better when Steve get the firmware out 

2534

General Mach Discussion / Re: Possible Mach3 tool compensation buh

« on: July 19, 2006, 10:39:40 PM »

You will need to offset with Cam software The line secmnets are to short to use Comp on

2535

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 19, 2006, 06:45:50 AM »

Great!

2536

General Mach Discussion / Re: Jerky Motion & Poor Quality in Curves

« on: July 19, 2006, 06:41:22 AM »

This feed rate will tell Mach3 how much to round the corner... So I woudl think about 25% the max feedrate of the machine should do.

2537

General Mach Discussion / Re: Jerky Motion & Poor Quality in Curves

« on: July 18, 2006, 11:50:49 PM »

That is the feedrate that the machine will slow down to when it goes around a corner

2538

Newfangled Solutions Mach3 Wizards / Re: Problem with Cut Rectangle

« on: July 18, 2006, 11:46:23 PM »

thank you David, I will be looking into it.

2539

General Mach Discussion / Re: Jerky Motion & Poor Quality in Curves

« on: July 18, 2006, 11:44:38 PM »

Set it to about 60 and that should do you...

2540

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 18, 2006, 11:41:49 PM »

Could you please see if you have anything in MSconfig? uncheck everything under the startup tab and I think it will work!
Also turn off the screen saver

Thank you
Brian