Messages

2981

General Mach Discussion / Re: Compatability with Anilam

« on: May 15, 2006, 10:11:49 PM »

I just did an Anilam Mill... I took the motors off and every wire out of the control I put on 1KW motors and got the mill doing 500IPM You could keep the motors but the drives are going to have to go...


Hope that helps
Brian

2982

General Mach Discussion / Re: Mini Lathe speed control

« on: May 15, 2006, 10:05:44 PM »

Check this out ... I think this is low cost stuff... http://www.kbelectronics.com/

2983

General Mach Discussion / I am out !

« on: May 15, 2006, 01:46:42 PM »

I am about to head out to the Workshop and I think they will have wireless for us to use at the workshop... So If I seem a bit slow I am sorry But I will try to do all the support I can.. 

Thank you
Brian

2984

General Mach Discussion / Re: retrofiting dyna 2800

« on: May 15, 2006, 01:06:09 PM »

Sweet    !!!!

2985

General Mach Discussion / Re: retrofiting dyna 2800

« on: May 15, 2006, 10:02:14 AM »

Use the Sherline mode and they will run great! it is on the ports and pins page...

2986

General Mach Discussion / Re: Homeing All Axis not working properly

« on: May 15, 2006, 09:58:03 AM »

It is doable... But you are going to have to write your VB script to probe the tool. I hope to have time to make the scripts but it is going to be some time... But if you work on it I wil help

2987

LazyCam (Beta) / Re: Lazy Cam?

« on: May 14, 2006, 08:09:48 PM »

That is a big help in finding the problem! Thank you!

2988

General Mach Discussion / Re: Homeing All Axis not working properly

« on: May 14, 2006, 08:05:55 PM »

There is a button that will help you with this ont the Settings page. just over the reset

2989

General Mach Discussion / Re: Help with Mach3Mill Motor Tuning

« on: May 14, 2006, 07:59:41 PM »

If you have a scope I think that is the best place to start

2990

General Mach Discussion / Re: Help with Mach3Mill Motor Tuning

« on: May 14, 2006, 08:05:24 AM »

This is odd you should be running at this point... So you have a PC4CNC board that is going to the geckos. Are there any led's on the board so you can see that it is getting pulses? Also when you install DO NOT uncheck the load driver. Be sure that the control is set to online. That is about all I can think of at this point.