Messages

1361

Mach3 and G-Rex / Re: Mach 3 Plug-in and Grex Current status.

« on: April 04, 2007, 05:25:22 PM »

MPG = No

1362

General Mach Discussion / Re: Mach3 XML file compatability

« on: April 02, 2007, 08:02:40 AM »

Yes but you need to save a backup of your XML and copy it back in after you install the latest version. Also if you have axis slaving please be sure to check you settings after you install.

Thanks
Brian

1363

General Mach Discussion / Re: MachTurn F DRO

« on: April 02, 2007, 08:00:41 AM »

That should be fine Good work!

1364

General Mach Discussion / Re: pulse width

« on: April 02, 2007, 07:58:30 AM »

You can take it up to 15 but after that you may lock up your system

1365

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 01, 2007, 08:28:58 PM »

Yup, that would be a simple card to add So mail me the cost and I will see when I can find the time to add them (About 6 months I an thinking)

1366

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 01, 2007, 08:15:26 PM »

The EMC guys make great software and work very hard on it! I have talked to the guys that write there software, What a great bunch of guys. They have done great things and without them we would not be here!

Like I said we could make that card work but it is all time Art and I would like to get all the more advanced stuff like that running in Quantum and have Mach3 as a low cost solution..

I am about to read the docs and I will tell you more when I am done

Thanks
Brian

1367

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 01, 2007, 06:45:15 PM »

Yes once I get it set up you wil be able to tap with non servo spindle

1368

General Mach Discussion / Re: MaxNC spindle setup

« on: April 01, 2007, 05:02:28 PM »

Thank you, we all work very hard to make this the best low cost CNC software on the web

1369

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 01, 2007, 02:34:34 PM »

Why do the PID loops and all the other stuff it can be done in the card It is all time and I think they have more time to work at that level. Art and I are doing support and adding to the code to make it work better for the users. We look at the hardware and there are only about 1% that will benefit from the work. We like to add code that will help 50 +%

You can mail the doc's to me at brianb ( AT  ) newfangledsolutions.com , looking forward to seeing them
Thanks
Brian

1370

General Mach Discussion / Re: MaxNC spindle setup

« on: April 01, 2007, 02:28:37 PM »

You should check out there doc's on the web first!