Messages

2191

Galil / Re: Mach3 + Galil

« on: September 20, 2006, 10:28:09 PM »

Good news we have started working on it and we hope to have it working in a few weeks...

After that I will be able to tell you more about how it works...

Thanks
Brian

2192

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 20, 2006, 10:24:26 PM »

Please tell me if you can't get it running... Mail me off list and I will see what we can do...

2193

General Mach Discussion / Re: Softlimits

« on: September 20, 2006, 10:21:54 PM »

I will be working on that tomorrow Thank you!

2194

Mach3 and G-Rex / Re: G100 jog problems-ART

« on: September 20, 2006, 08:30:55 AM »

Trust me I would like to have the firmware more then about  anyone and I know the problem that you are talking about

2195

Newfangled Solutions Mach3 Wizards / Re: Surfacing wizzard- just not getting it. Brian?

« on: September 20, 2006, 08:25:31 AM »

Yup, I have done it many ways I like to have the top of the block Z0 in the end becasue there is where I have all of my program running from

2196

General Mach Discussion / Re: Screen display when maximised?

« on: September 20, 2006, 08:22:30 AM »

What is your  resolution set to ?

2197

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 20, 2006, 08:20:56 AM »

Run msconfig and turn off any startup items... that will make it so you have a nice clean version of windows running.

2198

General Mach Discussion / Re: referencing not working in mach 3

« on: September 20, 2006, 07:20:45 AM »

Do you have the limit set up and not the Home input ?

Thanks

2199

Mach3 and G-Rex / Re: G100 jog problems-ART

« on: September 19, 2006, 07:50:16 PM »

This is a problem with the MAVG that is being set   If you pause for just a but this will not happen

This will be fixed in the next firmware release

2200

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 19, 2006, 07:47:23 PM »

Could you please run a driver test and tell me what you see in the graph? DriverTest.exe is under the Mach3 directory