Messages

2171

General Mach Discussion / Re: Losing zero ref - related to feed rate changes?

« on: September 24, 2006, 08:59:48 PM »

O that can't be a bug in mach2 I only worked on Mach3

2172

General Mach Discussion / Re: that cryptic status bar

« on: September 24, 2006, 08:25:05 PM »

If you post your program i will see what is going on...

2173

General Mach Discussion / Re: Losing zero ref - related to feed rate changes?

« on: September 24, 2006, 04:22:28 PM »

Is this in the new 2.0b version of mach3? If so it could be a bug in the Accel . I am working on the problem now

Sorry for the bug
Brian

2174

General Mach Discussion / Re: Acceleration problem

« on: September 24, 2006, 04:16:00 PM »

There is the angle and the CV feedrate on the settings page With this you can set the MAX CV feedrate that that will change the size of the Arc from move to move.

Hope that helps
Brian

2175

General Mach Discussion / Re: 6 axis?

« on: September 24, 2006, 04:12:41 PM »

http://www.mazakusa.com/productpage.asp?lngEquipID=7

 

2176

General Mach Discussion / Re: Separate Deceleration?

« on: September 24, 2006, 04:09:59 PM »

You are the first one to ask for it and I can tell you that it is not going to happen anny time soon There is a ton of code in Mach3 that is set up to work with the same Accel and deccel. Sorry

2177

General Mach Discussion / Re: setting up coolant pins

« on: September 24, 2006, 04:06:48 PM »

Yup you need a pull up resistor.. you could look into getting a new SSR that would use a few less mA.   I think there are a few webpages that tell how to setup a pull up resistor.

2178

General Mach Discussion / Re: that cryptic status bar

« on: September 24, 2006, 04:03:00 PM »

You need to know that center of the circle can be told to mach3 in two ways... in Inc or ABS if you see an arc error the best thing to try is change the arc center cord type and see if that fixes it. There is no way for us to tell in mach3 what you are loading for Arc types so there is no was to have the  error message tell you to change it.

Hope that helps
Brian
 

2179

General Mach Discussion / Re: Softlimits

« on: September 22, 2006, 07:25:50 AM »

I think I know what is going on here... Art has been working like a dog and I sent him the Code that I worked on and he just didn't add it to the biuld. It happens from time to time because he and I work on so many things at one time.

Sorry about that
Brian

2180

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 22, 2006, 07:23:01 AM »

There is nothing in the xml that you posted... Is this the right one? It is not in Max NC CL mode...

Thanks
Brian