Messages

2091

General Mach Discussion / Re: Memory leak in Mach3 ver 2.0

« on: October 21, 2006, 04:58:18 PM »

You ned to run a driver test on the PC if you re having trouble... you should have a nice straight line

2092

General Mach Discussion / Re: Grex and mach4 ( 3 )

« on: October 21, 2006, 04:56:25 PM »

There is no new firmware and as soon as we have that we will work on the plug in

Thanks
Brian

2093

General Mach Discussion / Re: Wrong Driver error

« on: October 21, 2006, 04:55:30 PM »

Run the Driver test and tell me what you get for a graph

2094

General Mach Discussion / Re: New Fixture save

« on: October 21, 2006, 04:54:38 PM »

Are you still having the prob;em in the new Rev2.x?

2095

General Mach Discussion / Re: Digital scales as input?

« on: October 21, 2006, 04:52:15 PM »

You would need to code it up in a Plug In in VC 2003 Look at the SDK's on the forum for more info.

Thanks

2096

General Mach Discussion / Re: Low Pulse Frequency

« on: October 21, 2006, 04:49:35 PM »

Use a desktop computer. Laptops are not good

2097

General Mach Discussion / Re: RS485/232 for axis

« on: October 21, 2006, 04:48:34 PM »

 would need to write a plug In to run the servo's like that. there is a problem with doing that because you can't move the data that you need to for 3d toolpaths... you are better of to use step and direction


BTW if you would like to do a plug in you will need VC++ 2003

2098

General Mach Discussion / Re: Post error

« on: October 21, 2006, 04:45:35 PM »

you need to look at getting a better post for master mastercam There are others here that run it or you can call them and I think they have one at master cam

2099

General Mach Discussion / Re: Setup units

« on: October 21, 2006, 04:43:02 PM »

If you would like to have an inch machine set the setup units to inch. then calc the steps per unit and put that into the motor tuning. if you need to have 3412.9437 steps per unit then that is okay

2100

General Mach Discussion / Re: 3d Digitizing PlugIn version 3.0

« on: October 21, 2006, 04:41:17 PM »

You should be okay with the new Rev2.xx

Thanks
Brian