Messages

1601

General Mach Discussion / Re: Parallel port clock signal to run a latch - is it possible with Mach3

« on: February 06, 2007, 04:45:30 PM »

I would buy a new breakout board... It is just not the trouble of working with the old one.

1602

General Mach Discussion / Re: Mach to DeskCNC?

« on: February 04, 2007, 05:52:02 PM »

Turn off the tool path and tell me if that helps

1603

LazyCam (Beta) / Re: relocating x0 y0 start position

« on: February 04, 2007, 10:19:33 AM »

Hmmm from what Chip found it looks like Lcam is reading a pointer that is no good .. I can;t get that to happen here!

1604

LazyCam (Beta) / Re: shut down message

« on: February 04, 2007, 10:17:11 AM »

I am working on a fix but it will have to be after the next major release

1605

LazyCam (Beta) / Re: Thanks to Brian & or Lazy cam Team! Please keep up the good work!!!

« on: February 04, 2007, 10:14:57 AM »

I don't think we will be adding that... but that is a VERY cool idea!!!!!!

Looks like we should have pocketing and Lathe!

1606

LazyCam (Beta) / Re: importing jpg bmp to lazycam

« on: February 04, 2007, 10:13:41 AM »

That is a first... what do you have for a computer?

1607

Third party software and hardware support forums. / Re: Microkinetics and Mach3

« on: February 04, 2007, 10:12:02 AM »

I just had a look at there docs and I think it should work! you may have to run in Sherline mode... Looks like they have nice stuff...

1608

Third party software and hardware support forums. / Re: ProfiBus, controlnet or devicenet support ?

« on: February 04, 2007, 09:55:26 AM »

No not at this time... it is on the list but that is a VERY long list

1609

General Mach Discussion / Re: Any way to know when job is finished?

« on: February 04, 2007, 09:53:32 AM »

There is also an "Estpo after M30" under general configs

1610

General Mach Discussion / Re: 'Mill dust' and breaking bits... Advice please...

« on: February 04, 2007, 09:51:48 AM »

I am a flood man as well.... The bigger the mess the more I like IT!!!!!! (I have a bit of a problem)