Messages

731

General Mach Discussion / Re: Saving WPO file ?

« on: September 16, 2007, 12:32:52 PM »

Okay I may be able to help but you need to tell me what is a WPO Work Position Offset? Have you changed the settings under general config? you can save them...

732

LazyCam (Beta) / Re: pocketing snag

« on: September 16, 2007, 12:25:46 PM »

There was some code that slipped back a few revs in the pocketing section and we need to go back and see if we can recode it ... that section of the code is an Art thing at this time so we will see if we can get him to get it working again. I will also be heading up to see him and I will learn about that section of code when I am up there

Sorry for the trouble guys
Brian

733

LazyCam (Beta) / Re: Lcam creates files MACH cannot run.

« on: September 16, 2007, 12:22:48 PM »

Well it is not as simple as it sounds... Comp is a BITCH to deal with... could tell me where you are getting the problem?

734

LazyCam (Beta) / Re: LCam still has minor problem

« on: September 16, 2007, 12:21:07 PM »

I was thinking that I fixed that ... Please keep telling me! I have so much to do that I am having a hard time to keep it all straight in my head

Thanks
Brian

735

LazyCam (Beta) / Re: tangential to track in lazy cam 2.02v

« on: September 16, 2007, 12:19:50 PM »

I can't do VB 

But I think I have all the code we need for the Tangential in Lcam at this time... I just need the time to make you a post and test What is your time line?

Thanks
Brian

736

LazyCam (Beta) / Re: LCAm enhancement needed

« on: September 16, 2007, 12:14:51 PM »

Swapping end to end... Are you talking about Mirroring??

A grid Hmmmnn.. I never use them  but it is a good idea so I will keep that one in the back of my mind.

Could you please save your XML and put it back at this time... with all the changes we are doing all the time we need to delete the XML But it should work most of the time to just copy in the old XML

Thanks
Brian

737

LazyCam (Beta) / Re: Automatic Z-Axis code.

« on: September 16, 2007, 12:10:05 PM »

You will need to make a Post Processor to change the code that is output. Here is one that you can use for now and there will be doc's at some point showing how to write your own

Hope this helps
Brian

738

LazyCam (Beta) / Re: Trouble Generating Pocket / Offset

« on: September 16, 2007, 11:53:02 AM »

I see the problem ... and the Problem is not in the code that we did it is in the code that we licensed.... I will see if we can get that one fixed by the supplier.

739

LazyCam (Beta) / Re: Tabbing - How To....

« on: September 16, 2007, 11:48:40 AM »

You can not move the tabs at this time

Thanks
Brian

740

General Mach Discussion / Re: confusion abounds -Turn -DXF import

« on: September 16, 2007, 10:57:31 AM »

I think there is a bit more work that needs to be done in the turn section of LCam at this time... We have been working on Mach3 so much that there has been no time . We hope that this will be over soon so we can wrap up Lcam.

Thank you and sorry for your trouble
Brian