Messages

2291

Mach3 and G-Rex / Re: G100/Mach3 features

« on: September 03, 2006, 07:12:12 AM »

Hood at this time I would just do the printer port version... There should be some new firmware out at some point that can make the g100 lathe ready But at this point the only hardware that we have to run a lathe is the P port...

2292

General Mach Discussion / Re: PC keeps rebooting after clicking Reset....

« on: September 03, 2006, 07:08:03 AM »

In the manual there is a section on uninstalling the driver. Please uninstall the driver and reinstall. Once you have reinstalled please reboot the PC. if you don't reboot you will get this same problem

Thanks and tell me if that helps
Brian

2293

General Mach Discussion / Re: Those pesky circles

« on: September 03, 2006, 07:00:15 AM »

okay ...put in a pulse width of 15 on the motor tuning page and see if that helps

2294

General Mach Discussion / Re: Can you stop release on outside jogging

« on: September 02, 2006, 10:10:40 PM »

BTW this problem is now fixed for he next release 

Yes any touch screen should work fine

2295

General Mach Discussion / Re: New PlugIn just about done..

« on: September 02, 2006, 10:09:02 PM »

okay can you go to device manger and get the Vendor ID for the shuttle Pro? this will help to see if we can get yours running

2296

General Mach Discussion / Re: Basic questions

« on: September 02, 2006, 10:06:28 PM »

That is it in a nutshell... but there are many little steps that need to be done as well we can help you with this

2297

General Mach Discussion / Re: Those pesky circles

« on: September 02, 2006, 10:04:47 PM »

John I need my lathe finished if you are looking for work

If you guys can't find the problem try sherline mode. this will give a very long step pulse and could help the drive (Whatever they are)

2298

General Mach Discussion / Re: New PlugIn just about done..

« on: September 02, 2006, 12:58:10 PM »

It will do that if you have it set to velocity mode

You were thinking you had me that time... NEVER HAHAHAHAHA (Evil laugh) 

2299

General Mach Discussion / Re: Softlimits - Message

« on: September 02, 2006, 12:54:15 PM »

This is being looked at and I there should be a fix in the next version or so...

2300

General Mach Discussion / Re: New PlugIn just about done..

« on: September 02, 2006, 08:48:07 AM »

David,
Yes it should just work.. did you set it up on the settings page? and do you have a shuttle Pro 2 or one of the other ones?


Jon,
Yup it works like an MPG every click is at the inc that you have set if you are in Inc mode if you turn it to fast it will not keep up but it has a good feel..

I think it should work on a non usb2 but I done have one here that I can check that on