Messages

771

General Mach Discussion / Re: gecko g340

« on: September 04, 2007, 08:30:52 AM »

You need to have the two power supplies with the same common... That is why you need to connect the ground lines of the two power supplies...

You can get encoders from UsDigital that will work very well with the Geckos..

Thanks
Brian

772

General Mach Discussion / Re: Mach 3 + Featurecam + Drilling / Gouging / Broken Cutter problem

« on: September 04, 2007, 08:27:52 AM »

This is one for 2005 I think but it is a good start..
thanks
Brian

773

General Mach Discussion / Re: Help in settings...

« on: September 04, 2007, 08:24:00 AM »

Hello, Have a look on the downloads page and you will find the optimization guide, in this will will find all the steps needed to get your steps a bit smother..

774

General Mach Discussion / Re: 3rd Annual CNC Workshop - Kansas

« on: September 04, 2007, 08:21:40 AM »

"weird bunch (of good hearted souls) " I would say that is right

If there is anyone that would like to know how to make things with there router this is "the" place to be!!!!

Keep up the good work and tell my how many people you get at the workshop Gary...

Thanks
Brian

775

General Mach Discussion / Re: finding x0 yo

« on: September 04, 2007, 08:17:44 AM »

It is all in the rev that you have you can test the G68 by typing in the angle on the MDI page..

Hope that helps
Brian

776

LazyCam (Beta) / Re: Latest Vers of LazyCam?

« on: August 26, 2007, 09:35:01 AM »

The new revs of Mach3 are with the blue background and if you have a rev with the black background it is old and you should update... Also the new rev numbers came in with the new background and interface.. this was a major rewrite and basically it is not even the same program! This should be the only time that we need to make such a big change (I hope)

Thanks
Brian

777

LazyCam (Beta) / Re: tangential to track in lazy cam 2.02v

« on: August 26, 2007, 09:27:00 AM »

I have added your Tangential code to Lcam.. I should have it ready for testing in a few weeks

Thanks
Brian

778

LazyCam (Beta) / Re: Tabbing - How To....

« on: August 26, 2007, 09:23:49 AM »

There is a problem with the tabbing a circle but this is the only problem that is reported at this time... Not to bad for the first time out...

779

General Mach Discussion / Re: "run from here" problem

« on: August 26, 2007, 09:19:14 AM »

The problem is this function is not available without registering the software.
Sorry
Brian

780

General Mach Discussion / Re: trouble with steps or with stream pulses

« on: August 26, 2007, 09:14:30 AM »

sounds like you have backlash in the screw... try setting your backlash comp to.001 and see if that is any help..

thanks
Brian