Messages

971

General Mach Discussion / Re: Work offsets not being saved

« on: June 29, 2007, 11:16:45 AM »

Fixture.dat is the file that the offsets are saved in...

Also please get the latest version and see if that will fix your problem

Thanks
Brian

972

General Mach Discussion / Re: Cutting slopes in foam

« on: June 29, 2007, 09:10:30 AM »

You will need to look into other Cam software that can do 3D Sorry we are not able to do it at this time.
Thanks
Brian

973

LazyCam (Beta) / Re: LazyCam tabbing feature

« on: June 29, 2007, 09:08:36 AM »

I have added all the math to make the tabbing feature, I just have not had the time to finish ;( It will be in the software at some point It is still on the list and i keep getting closer to it everyday!

Thanks
Brian

974

General Mach Discussion / Re: Work offsets not being saved

« on: June 28, 2007, 11:04:04 AM »

Did you try changing the settings under the general configs?

Thanks
Brian

975

General Mach Discussion / Re: Cutting slopes in foam

« on: June 28, 2007, 10:58:46 AM »

What do you have for Cam software? That is going to be a 3D cut

976

General Mach Discussion / Re: Mach3 won't reach last position requested in G Code

« on: June 27, 2007, 10:19:07 PM »

Cool You will be making parts in no time!

Thanks
Brian

977

General Mach Discussion / Re: Mach3 won't reach last position requested in G Code

« on: June 27, 2007, 09:11:48 AM »

Hello Chris,
Please retune your motors in the motor tuning and save the the settings. I can see that your motors are set to go faster then you have the driver set to run. That should fix your problem.
Thanks
Brian

978

General Mach Discussion / Re: Mach3 won't reach last position requested in G Code

« on: June 26, 2007, 04:02:00 PM »

Please check your motor tuning settings... It sounds like you have your X axis motor vel higher then Mach3 can drive it

Also if you would like please post your XML and I will have a look at it

Thanks
Brian

979

General Mach Discussion / Re: Help! Is my controller losing steps?

« on: June 26, 2007, 03:56:17 PM »

Run the Driver test and post a screen shot of what you get please. I think you are having trouble with your compter and Mach3.

Thanks
Brian

980

General Mach Discussion / Re: FYI Onboard video and video card

« on: June 26, 2007, 03:53:52 PM »

I have had the same problem in the past

Glad to hear that you got it working!