Messages

1891

Tangent Corner / New cnc project

« on: December 09, 2006, 10:11:17 AM »

I was thinking that this would be a good project for a few of you outthere
http://www.ronpatrickstuff.com/

1892

General Mach Discussion / Re: I'am new on your site......and a total beginner...

« on: December 08, 2006, 08:49:15 AM »

You could also look at getting a finished drive set from Alan at custom-cnc.com or Bob http://www.campbelldesigns.com/

Didn't know if you would like to have a finished product

Both have Geckos

1893

General Mach Discussion / Some new Breakout boards that use an index pulse

« on: December 08, 2006, 08:40:51 AM »

There are some new boards out there ( www.cncbuildingblocks.com ) that work very well for those of you with servos... with this board you can home off an index pulse and I know there are a few of you out there that would like to know about such a thing I have one of his boards here and I must say they look very nice! I wish I could do 2% of what the hardware guys can do!! Thank you to all you that make hardware to hook into Mach3!

1894

General Mach Discussion / Re: CONTOUR PROBLEM! Machine takes shortcuts on corners !

« on: December 08, 2006, 08:00:54 AM »

Yup G61 is needed for that job

1895

Newfangled Solutions Mach3 Wizards / Re: cut rectangle wizard

« on: December 07, 2006, 10:36:08 PM »

Can't turn off the leadins besause it needs them for Comp.

1896

LazyCam (Beta) / Re: LazyCam ver 2.64 and G(Mode) generation of G41, G42

« on: December 07, 2006, 10:30:46 PM »

Check for a bad drive and were the DRO's still moving?

1897

LazyCam (Beta) / Re: lazy cam with version 2 mach 3 photo engraving prob

« on: December 07, 2006, 10:24:13 PM »

If you are at zero and you would like to move to zero there is no need to send out a move... Set the rapid height and you should be good

1898

General Mach Discussion / Re: Toolpath in Lathe-Mode

« on: December 07, 2006, 10:06:46 PM »

You can't rotate the tool path in Lathe

it was turned off because it is not needed

Thanks
Brian

1899

General Mach Discussion / Re: Mach to DeskCNC?

« on: December 07, 2006, 10:00:59 PM »

You don't need to have the SD card to run it with Mach3

Thanks
Brian

1900

General Mach Discussion / Re: About the Licence restrictions

« on: December 07, 2006, 09:42:23 PM »

If you are using it on a machine to make money you need to get a other license file... If you are at home and running routers to make things for the kids you inly need one
So if you need a copy in the office go for it!
We are nice about this

Thanks
Brian