Messages

1861

General Mach Discussion / Re: Problems with movement with Large program loaded

« on: December 17, 2006, 10:13:41 PM »

You can turn off the toolpath  on the Diagnostics page and it will help with the problem...

thank you

1862

Feature Requests / Re: Remove buffered outputs

« on: December 16, 2006, 05:09:54 PM »

You need to add code in VB to make this happen   If you need help I have done it in the past... You can use LED's to make it work

Thanks
Brian

1863

General Mach Discussion / Re: Config Fonts Doesn't Appear to Work

« on: December 16, 2006, 05:05:00 PM »

If you need to have the DRO's larger you will need to make a new screen set

1864

General Mach Discussion / Re: Problems with movement with Large program loaded

« on: December 16, 2006, 04:59:58 PM »

You can turn off the toolpath for the very large files...

1865

General Mach Discussion / Re: error messages

« on: December 16, 2006, 04:56:17 PM »

That is odd... that is telling me that the Driver did not install If you try it again be sure that you reboot the system and  then install.

1866

General Mach Discussion / Re: Edge Probing

« on: December 16, 2006, 04:49:10 PM »

There are no tools to make probe points into a Gcode profile... You would need to take the points into a Cad system and draw the profile from them.

1867

General Mach Discussion / Re: max feed rate?

« on: December 16, 2006, 04:46:53 PM »

Press the Tab button and see what your jog % is set at please... Also try testing a jog by pressing the Shift key then Jog an axis (this will make it move at 100%)

How is that?

Thanks

1868

General Mach Discussion / Re: Change speed and zero fifth axis

« on: December 16, 2006, 04:43:30 PM »

Tell me if you have any trouble

1869

General Mach Discussion / Re: I'am new on your site......and a total beginner...

« on: December 16, 2006, 04:42:47 PM »

Where are you and we can see if there is some hardware that is local to you?

Thanks
Brain

1870

General Mach Discussion / Re: Mach3 thinks it's moving Z from THC but Torch height unchanged

« on: December 16, 2006, 04:35:00 PM »

No there is a setting that is the speed setting for the plasma correction rate.. If you could please post or send me your XML and screen set that you are running and I will see where you have the setting

Thanks
Brian