Nope, it is not a nerve
I am just trying to set everything straight... Mail and Forums are not that good at showing emotion
In Quantum we are going to change how all this is done and I think you are going to like how we are going to work it... We are going to take the settings and move them to the PlugIn. There you will only have the settings that you need... But you have to know that you are doing something that you only do one time, If you have to change your Pin settings every time you run your mill I think there is a problem
.
You will not see any Docs on Sherline more because it was done to make Sherline mills work in Mach3. It just happens to be something that helps other drives as well (2-3 years later). You can check Sherline mode but it is not going to change anything in the driver
We locked out the settings in the code.
You are correct MaxNC mode is only setup in one direction, It should be the correct direction, I hope
The Checks that you are looking for can be added but this is a section that we get such little support on that we have not taken much time to go back and add code. We are going to keep working on bugs and get the software running as good as we can for the users and after that we will see... It may be time to go back and add a few dialogs for you
Later and best of luck with the mill!
Brain