560
« on: October 17, 2009, 10:29:13 PM »
Id like to see a way get a VB Sub attached to each DRO that would be called when the DRO is changed by the user.
In almost every wizard screen the user can update a bunch of DRO's then finally pushes a'write code' button. Then I have to run through all the DROs to be sure they are valid and pop up error messages.
It would be much cleaner if when the user tried to change a DRO I could instantly error check it and popup an error then, while hes still looking at the DRO.
The VB code would not be run if the system changed the DRO value, or if some other VB code changed the DRO- only when a user enters a new value.