Hello Gerry,
I've been configuring your screen and noticed the RefAll sequence (M884.m1s) was different than the one I used.
This is your original:
------------------------
DoButton( 24 )
'Code "G53 G0 Z-1"
'While IsMoving()
'Wend
DoButton( 23 )
'Code "G53 G0 Y1"
'While IsMoving()
'Wend
DoButton(22)
'Code "G53 G0 X1"
'While IsMoving()
'Wend
--------------------------------
This is the one I inserted(replaced):
-------------------------------
DoButton( 24 )
'Code "G53 G0 Z-1"
'While IsMoving()
'Wend
refcombination( 19 )
-----------------------------------
Art had included this, I just used it.
Basically, all it does is Ref both X and Y axes simultaneously after first referencing Z.
It works as intended, but was just wondering if it will create problems anywhere else in your screen functions.
Thanks,
John(Bloy)