Messages

231

Show"N"Tell ( Your Machines) / Re: Novamill

« on: July 12, 2012, 11:33:08 AM »

bt30

232

Mach3 under Vista / Re: unable to set debounce >9

« on: June 21, 2012, 11:45:41 AM »

you need to press ok at the bottom of the screen

233

Show"N"Tell ( Your Machines) / Re: Novamill

« on: June 21, 2012, 05:19:07 AM »

you should be able to get 1500 - 2000mm/min rapids on the novaturn and novamill. I would have expected more from that setup.

234

General Mach Discussion / Re: ShuttlePro

« on: June 20, 2012, 12:37:34 PM »

the centre is a step jog wheel and will move per step, and the outer is fast jog with seven ascending rates for each direction

235

General Mach Discussion / Re: ShuttlePro

« on: June 20, 2012, 12:00:29 PM »

i didn't think you could program the dials, surely you alter the setting in mach for different reolutions

236

General Mach Discussion / Re: Mach 3 resetting the screen and configs by itself

« on: June 20, 2012, 09:55:09 AM »

that's sop for most programs.

237

General Mach Discussion / Re: Mach 3 resetting the screen and configs by itself

« on: June 20, 2012, 09:54:38 AM »

you have to close mach for the xml changes to be saved

238

General Mach Discussion / Re: Mach 3 resetting the screen and configs by itself

« on: June 20, 2012, 09:32:06 AM »

there is something odd about the way or place windows 7 stores the xml, i can't remember off hand where or what happens but someone else may be more aware of this. Try searching for copies or looking for strange directories.

239

General Mach Discussion / Re: Spindle control lost after PC computer changeover.

« on: June 12, 2012, 06:01:26 PM »

check the bios on the new computer to see if the parallel port setting is on ECP, if it is change it to EPP. This is known to stop the spindle signal.

240

General Mach Discussion / Re: Motor Pin Numbers Changing Randomly....HELP PLEASE

« on: June 05, 2012, 06:51:22 PM »

it's possible that the other mach is causing the trouble, try renaming the older mach directory and it's xml