393
« on: February 06, 2011, 08:01:12 PM »
i get the feeling that you've not set the work offsets correctly. Try this, home your machine and make sure the dro's are set to machine coords, which should read zeros Then jog the tool to the start point of the job and go to the offset screen and and enter the dro values in the current work offset dros and save then at the bottom of the page. If you go back to the main screen and press the machine coords button it should read zeros, and whaen you press it again it goes back to the distance you're from the mome switches. Then try the code.