Messages

421

General Mach Discussion / Re: Denford Starmill

« on: December 19, 2010, 04:42:19 PM »

I've had a nose at the layout of your nee starmill, and it looks relatively easy to convert. I've also answered your post on the denford forum regarding the y axis problem you have.

422

General Mach Discussion / Re: losing steps

« on: December 15, 2010, 05:07:31 PM »

With the spindle on a high speed, do you hear or can you feel a slight clunking noise from the table.

423

Tangent Corner / Re: water saving device?

« on: December 13, 2010, 12:40:32 PM »

I hate to think what with.  

Tweakie.

Air, of course

424

Show"N"Tell ( Your Machines) / Re: AL54b (lathe) project from New Zealand

« on: December 10, 2010, 05:13:40 AM »

how about AL54B 2011

425

FAQs / Re: Steppers won't reference

« on: December 02, 2010, 08:19:52 AM »

I had a similar fault, and it turned out to be a loose ground connection.

426

General Mach Discussion / Re: What does the "To Go" button do?

« on: November 28, 2010, 08:26:21 AM »

eco, i get the feeling what you need is to be shown the use of mach3 on a machine. If you give your location there may be a member close to you willing to spend a few hours with you either at your machine or thiers.

427

Show"N"Tell ( Your Machines) / Re: AL54b (lathe) project from New Zealand

« on: November 21, 2010, 04:20:07 AM »

motor would be the 2

428

General Mach Discussion / Re: Machine coords button

« on: November 20, 2010, 06:26:09 PM »

I shall have a nose and see what i can do.

429

General Mach Discussion / Re: Turn on an Output? Shamefully simple?

« on: November 20, 2010, 06:16:23 PM »

most outputs sink more current than source.

430

General Mach Discussion / Re: Machine coords button

« on: November 20, 2010, 06:14:38 PM »

that sounds good, now the best bit....how?, in laymans terms. i've not delved into changing screens at all, so i've no idea.