Messages

371

General Mach Discussion / Re: Denford Orac 8 station turret

« on: March 24, 2011, 06:00:56 AM »

Stefan


Not sure who Jr is?

Hood

Have you not watched Dallas

372

General Mach Discussion / Re: How to wire and run automatic oiler?

« on: March 22, 2011, 05:53:01 PM »

you could use the dryway sensors from http://www.cantkeepitoily.com

373

General Mach Discussion / Re: Homing to slow

« on: March 22, 2011, 06:45:26 AM »

i set my % value at 30% which makes it 50% faster with no adverse effects. Or as overloaded said, jog to near the home position then home.

374

General Mach Discussion / Re: Trouble with lathe spindle speed in Mach3Turn

« on: March 20, 2011, 02:19:26 PM »

with 2000 in steps per, try 80 in velocity and 125 in acc.

375

General Mach Discussion / Re: Trouble with lathe spindle speed in Mach3Turn

« on: March 19, 2011, 02:01:19 PM »

have a nose in general config and set the index debounce to 1

376

General Mach Discussion / Re: Denford Orac 8 station turret

« on: March 18, 2011, 05:20:15 PM »

take the toolplate off and there should be a cover, underneath it is the ratchet/pawl.

377

General Mach Discussion / Re: Denford Orac 8 station turret

« on: March 18, 2011, 03:32:35 PM »

have a nose at the ratchet assembly, and grease it well.

378

General Mach Discussion / Re: Loosing steps when milling slowly

« on: March 07, 2011, 10:23:09 AM »

in config/general config raise the debounce interval to 2000.

379

General Mach Discussion / Re: Sherline mill 5400 - Motors not moving the didstance Mach3 DRO shows

« on: March 06, 2011, 07:10:13 AM »

it may help, if you tell us how many steps per unit you have it set too on each axis.

380

General Mach Discussion / Re: Loosing steps when milling slowly

« on: February 26, 2011, 03:07:12 PM »

have you tried it with the acceleration at a lower setting.