101
General Mach Discussion / Re: spindle speed problems
« on: February 26, 2013, 11:19:51 AM »
have you set the spindle pulley.
What inverter are you using, the original?
What inverter are you using, the original?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
thank you for your quick reply i will go into the workshop & try it nowI can't remember what the orac gearing is, so i'm not sure on that one. Also make the index debounce 0 ( general config, click ok )
something i forgot to put on my earlier post is is the spindle is driven by a poly v belt & the motor pulley is 40mm dia & the spindle pulley is 60mm dia, would this make any diference to what you have suggested i should try
robert