I have a new version, 1.05 that includes the following:
V0.05
change Xstart-Xend test on bore to be a warning, not an error
changed Turn so Xstart is stock dia, first cut will be Xstart-Xcut
also now will make cuts as specified, with last pass smaller.
Fixed all DRO to allow 4.4 format, shiftedd and aligned to improve layout
Added Single Block button to Run screen
I have some concern about the Bore cycles with negative numbers. I cant quite get my head around that with a rear tool post,so I may be allowing an invalid condition, or it may get into some loop. Be very cautious if you try this.
As always the new version is in the first reply of this topic. Be sure when you unzzip it that it winds up in Turnaddons/NFSturn without a version number.