How did you keep the cylinder liners from spinning during the machining?

Vince

The liners are pressed in. I also put a dab of green loc-tite on them.

Ok Steve, so who is it going to be, Ed, me, or the pretty gal on the corner ..........

After these are done, If I ever make more after that, I'll make you both one.

Victory!

Both blocks are completed! Not sure where i'm going to go from here. I have to work 12 hour days for the next week so I will have lot's of time to figure it out!!!!!

Beautiful work, very well done

Steve,

By the time I get this far into a project I have to get the guys in to empty the trash out of the skip. 

It really does require a tremendous amount of skill to put in that amount of machining without a major snafu - keep up the good work and pictures please.

Tweakie.

Tweakie,
"empty the trash out of the skip"
Sorry, I guess I need an American translation,  

This project is great to watch, cant wait to see it run. Keep up the great work.

It really does require a tremendous amount of skill to put in that amount of machining without a major snafu.

Thanks guys!

I haven't had much time lately because work has gotten out of control a little. When I get something done, I'll get you updated.

Who say's I haven't had any major snafu's. If I didn't, there would be 3.

Both blocks are completed! Not sure where i'm going to go from here.

Please forgive a silly question, but I have to ask. Is this thing going to actually run???
Mind boggling.

Cheers

Please forgive a silly question, but I have to ask. Is this thing going to actually run???

Yes that is the plan. I started building air and steam powered stuff about 4 years ago and it has lead me into gas powered stuff. I finished my first gas engine and have been hooked.

First effort was a V4

Video: http://www.youtube.com/watch?v=1-JRQGPswVA
Photos: http://www.floridaame.org/GalleryPages/g1M0348.htm

Quote from: rcaffin on September 08, 2010, 06:51:19 AM

Please forgive a silly question, but I have to ask. Is this thing going to actually run???

Yes that is the plan.

Unreal!

Cheers