HIYA STEVE, try this, talk to CamBam and show them your toys and explain how you do show and tell all over the world (WWW) and see if they will give you an OPEN seat for your show and tell work with cambam as your CAM .

Been known to work,(;-) TP

What good is it if i cant figure out how to use it? MeshCam was easy to use, maybe I should write to them.

Your moving right along with that V8. Very nice, I must say. Thanks for taking the time to share your progression with us.

I beleive that alibre has a CAM modual as well . Might drop them a line. Heck the worst they can say is NOPE.

Steve I talked with andy and he is interested in helping you understand how CamBam works if you are interested.

Let me know, (;-)

Steve I talked with andy and he is interested in helping you understand how CamBam works if you are interested.

Let me know, (;-)

I am interested. I looked into Alibre CAM $1,000. Aint no point in looking any farther into that.

Steve I talked with andy and he is interested in helping you understand how CamBam works if you are interested.
Let me know, (;-)

There is going to be a slight delay in the program. I have the Gcode for the intake 80% done and that part will be made shortly. After that I will be switching to CamBam for all my Gcode. If I don't jump into it fully, I will never learn it so that is what I will do. There wont be much happening while the learning curve is kicking my a$$ but in time it will be worth it. I will start out with the most simple parts that need pocketing and drilling and work my way from there. Bear with me and this thing will get back on track soon (I hope).

attaboy Steve. go get um buddy. (;-) It won't take long

A wise choice, in my opinion.

This is the bulk of the CNC work for the intake. Still need to drill the ports and the hole for the distributor.

That's it for the night. I think one more night and It should be completed.