1531
General Mach Discussion / Re: cutting complex plan
« on: June 30, 2010, 06:43:46 AM »
If the parts you want are the octagons then lose all the other lines and separate each octagon by at least 2*kerf width. Adding to what Terry's said - you can't have objects touching - what about your kerf? and even if you intend to use the .DXF AS the path rather than have sheetcam generate an offset path, cutting over an existing kerf is not a good idea. Also the golden rule of "kerf to the left" is not possible if two or more objects share the kerf.