1261
Screen designer tips and tutorials / Re: Very Cool LED/Button Combo
« on: March 04, 2009, 01:16:14 PM »
Ooopsie! I didn't include the bitmaps, etc. The attached should do it.
Regards,
Ray L.
Regards,
Ray L.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I asked that exact question on another forum (awaiting reponses) and am drafting an email to Gecko right now, it's easy enough to remove a few more turns from the transformer if needed...
What does an energy dump circuit look like?
Well I received my smooth Stepper board and my three Gecko drives (320's). I've gutted my old controls off the machine and rewound the existing transformer to give me 77 VDC to power the Gecko's. Just ordered a Sound Logic encoder interface board from Rogersmachine.net to work along with my smooth stepper. I believe these two should handle everything I need right now.
Well I received my smooth Stepper board and my three Gecko drives (320's). I've gutted my old controls off the machine and rewound the existing transformer to give me 77 VDC to power the Gecko's. Just ordered a Sound Logic encoder interface board from Rogersmachine.net to work along with my smooth stepper. I believe these two should handle everything I need right now.
we are running geckodrive servo 6320 on a plasma cutter. I don't think we have ever run 6 continuous yet, but as for overheating not sure how to check that other than put my hand on them and none have ever been hot. the problem has mostly been with the "y" axis. We will be running through a pattern then in the exact same spot every time the gecko will fault. It doesn't stop it just re-zoroes at that point and continues cutting the part.
Thanks for the info