doesnt make any sense.And why the double image is produced in the one axis(x) direction?I have to mention that my x axis has faster speed than the y axis!

Certainly a mystery.
Could you possibly post a picture of the result and a copy of the test image you are using please ?

Tweakie.

I will make some samples and posted tommorrow,if this ok!Thanks you very much for your help.

could you post a simple test image that you have already tested and your plugin screen(settings).To make a sample on this?

Something like this would be good.

Say 30mm x 30mm, Stepover 0.5mm, Feedrate 20,000 (not inverted)

Tweakie.

This is the result I get from the above image settings.
The scan starts bottom left and it can be seen from alternate lines that there is a slight delay where the laser turns on and another slight delay where it turns off. This delay is so small that it makes no difference to the quality of photos or other images processed by the plugin.

Tweakie.

I ll try it first thing tomorrow.

Tweakie good morning.These are the results.
1 st photo  30x30 0,5  20000
2nd    only change the feedrate   7000
3rd   feed        4500

here are the photos

As you see for 20000 the images are 2 and the power output is too strong(how I can modify the output?)
with 7000 the images come closer thats why you see totally burnt in the middle where the two imagew meet
4500 the same but here is more obvious.The black is where the two images meet..........