Had a look at removing the solenoid valve manifold/panel and its not a 5 minute job so I decided to just solder a couple of wires in the main plug and bring them out to tool 9's up coil. It worked well and tool 9 is now fully operational. I think I will at some point however try and remove the panel and find out what the actual problem with the circuit board is.
I got the tool arm mount from tool 10 removed yesterday. Someone has tried to remove it before as 2 or the three capscrews were missing and the third was rounded. As it is at the back and actually inside the head casting it is quite awkward to get to but I called for the cage to lower which gave a bit more access. I tried tapping a torx driver in but couldnt get in straight enough so borrowed a right angled drill from the boatyard and managed to drill the head off the capscrew.
I got the cylinder fitted , two prox's fitted and also the tool arm then finally I got the mount screwed back in place. Got it piped up and the prox's wired and it to is now working. I have all the tool arms fitted now so all that remains is to get the swing doors made up for two of the arms.
All 12 tool positions are now working but I forgot to put a bit of damping on tool 10's cylinder so it comes down a bit faster than I would like. Hopefully I will manage to get my hand in to adjust it a bit, if not I will just drop the cylinder and give it a turn.
Heres a vid of all 12 tools now working.
http://www.youtube.com/watch?v=oJ8KAuzgSjEHood