Dave how are you controlling THC?
Is it via mcode?.... Or what?
Hi
Yes, sort of.
Its a CandCNC MP3000-DTHC2 so has the ability to set THC via the CAM, I set everything in SheetCam - Volts, Pierce delay, THC on/off, THC delay etc.
I use Sheetcam rules to turn the THC on/off on corners but since setting my anti-dive and tip-saver i might stop this and see what happens.
The MP3000 has its own cpu and talks to Mach via the serial port, when you load a code file the settings are sent through to the THC and stored there.
I use the M10p/M11p (?) codes to turn the torch on and off and none of the THC commands cause any pauses in motion.