Please help me a little longer.
1. I have a digital servo motor.
2. I have a motion control Galil DMC-4143.
3.mach3 software.
I want to make the machine as a close loop.
I've tested as follows.
- I've set motion drive DMC-4143 by galil tool soft ware (MTA = 2) and set motor type in galil pulgin (Motor type = servo motor) and I jog command from an error on the mach3 then drive DMC-4143.
But if I set motor type in galil pulgin (Motor type step), I used to jog from mach3 it ok. But it was not a close loop.
How do I fix it.
Thanks.