294
« on: November 06, 2007, 01:53:05 PM »
TP
After finding out the fact the DIY drives won't fit the bill i am going to back and look at the drives in the machine, problem is who ever had the machine before me coobled so much to the electrical system I found it hard to make heads or tails of it but i did make my way through it and found one of the power supplies over voltage to the drives and i don't know if it hurt them i am going to look at repairing the power supply or replacing it just didn't want to through good money after bad and in the end finding out i needed to replace it all anyway don't mind spending some money but having been down this road before and getting screwed over with promises i don't want to repeat this again.
Dennis