Messages

371

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 16, 2007, 03:46:56 PM »

Hey Brett
You offered a phone call is it possible to call you what's your #

Dennis

372

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 16, 2007, 03:45:57 PM »

Hi Brett
I am using it fo rmy lathe soit's X & Z axisis

Dennis

373

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 16, 2007, 03:37:33 PM »

Hello Hood
 Thanks for the reply, well it the same as my Z and i tried different setting's on the ports and pin's but still no movement on the X

Rg's
Dennis

374

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 16, 2007, 01:37:45 PM »

Hello again guy's
I hope you guy's don't get tired of the newbie questions and problems, well after getting the system working over the week end i turned the system on this morning and now i get no X axisis movement and the X axis movement on the screen dosn't change when i jog but the Z axis dose what did i turn on off ,going through the learning curve thanks guy's

Rg's
Dennis

375

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 07:04:02 PM »

Any one else using the CNC4Pc board thanks to all you guy's i have my lathe running X&Z axisis but i still have one of the transistors on the board getting very hot and i am affraid to run it for long in fear of blowing the transistor any ideas as to what it could be.

Dennis

376

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 06:51:38 PM »

got it going not sure what i did but i am getting jog now wow thanks all you guy's i am sure i will be back with more questions.

Dennis

377

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 06:49:21 PM »

nope charge pump is dissabled set to 1&2

378

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 06:47:40 PM »

I have enabled the jog led is on on the upper right hand of screen and jog rate is set to 100 % i hit the tab and arrow for the x axis but no movement

379

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 06:29:32 PM »

Ok that's what i thought should work the jog but still no movement from the stepper

380

General Mach Discussion / Re: re: Mach-3 for a lathe

« on: April 13, 2007, 06:25:11 PM »

how do you get Mach-3 to jog