Messages

251

LazyTurn / Re: LazyTurn

« on: July 30, 2008, 11:12:20 AM »

Overloaded
 Sorry if i made you think it was a finished product i poorly stated a thought, my thought was that from the test version it looked as though the program was ready to go.

Rg's
Dennis

252

LazyTurn / Re: LazyTurn

« on: July 28, 2008, 06:31:18 PM »

Great Work Art
It's exactly what i would expect, it ran as it should waiting for the finished product it looks like it should run ok now.

rg's
Dennis

253

LazyTurn / Re: LazyTurn

« on: July 19, 2008, 02:10:59 PM »

Art
Thanks i will be looking at it hopefully it won't be to long until a working version is available.
Dennis

254

LazyTurn / Re: LazyTurn

« on: July 16, 2008, 07:03:34 PM »

Hello Art & everyone
Just checking in, is LT available yet for any kind of testing i have been waiting since i first purchased Mach-3 and LC it's the reason i bought it in the first place.


Rg's
Dennis

255

General Mach Discussion / Re: mill retro HELP

« on: June 05, 2008, 10:54:37 AM »

Hello Ed
 Just reading through your post i have a retrofitted a lagun mill with Geckos the motor's are servo type 120 volt i am running the geckos at a reduced voltage right now which is 55 Volts the motor's and the mill work just fine my plan for the future is to change out the power supply to 75-80 volt unit don't know that the mill realy needs it though good luck with your project.

Dennis

256

General Mach Discussion / Re: Cad Cam software

« on: June 02, 2008, 10:40:59 AM »

in the same boat i have a little G-code experince but since these are my own machine's i can't afford to screw them up because then i would have to pay can't just say i sorry to the boss and i screwed up.

Dennis

257

General Mach Discussion / Re: Cad Cam software

« on: June 02, 2008, 10:33:20 AM »

Dave
No i have not used L cam the difference that I see first off is that you can draw in the 2DNC program and then edit a DXF file I first purchased Mach3 to use on my lathe with L Cam but now it's lazy turn and it's not finished or working yet so i need a program i can use to draw my shapes in and then convert them to g-code i am not very good at G-code.

Dennis

258

General Mach Discussion / Re: Cad Cam software

« on: May 31, 2008, 12:16:09 PM »

Dave
On the top of the this site is a downlaod page there you will find the link D2NC on that webs site they give a demo and video of the software looks interesting and not very expensive.

Dennis

259

General Mach Discussion / Cad Cam software

« on: May 30, 2008, 12:29:22 PM »

Hey guy's
anyone have experince with 2dnc i have looked at the video it looks like a good program not very expensive any one use it how's it do.

Rg's
Dennis

260

General Mach Discussion / Re: Need info on Denford Starturn 4 CNC lathe

« on: April 22, 2008, 06:48:29 PM »

Fred
Just received your post all i did was connect my lathe to the 220 outlet and off it went I'll see if i can find the Denford number for you to call you have to ask the operator for tech support they are in Ohio i think it's been a while now and i have no more need to contact them as i have only the bed, steppers and spindle that is original.

Dennis