Messages

181

LazyTurn / Re: LazyTurn

« on: March 12, 2010, 12:05:57 PM »

Hi Rich
My lathe dose have a turret tool post and yes all the tool's are close but i am sure not exact in length reason for my comment it gets confusing when you are homing different tools and then doing multiple parts with the same code.
  i have used LT and get the same type of results as Chip had above meaning the code is not the same each time out but using the same DXF for a file is LT using a different approach to the each time it generates the G-code?

Dennis

182

LazyTurn / Re: LazyTurn

« on: March 11, 2010, 12:08:35 PM »

Hi Art & Rich
Are you saying if a tool change is in the program the operator would have to home that tool to the material can't see that working as it would change the profile i am lurking and watching i have not put tool to metal yet only a Sim and i don't think LT is there yet very close though thanks art for what you have so far.

Dennis

183

LazyTurn / Re: LazyTurn

« on: February 25, 2010, 02:08:02 PM »

Found it just to many folders thanks happy chip making.

Dennis

184

LazyTurn / Re: LazyTurn

« on: February 25, 2010, 11:49:37 AM »

Hi Rich
Thanks for the reply i have alway's installed it in the Mach folder but now when i open the folder the icon is not there i did a search but it just showed a folder and the icon was not inside don't know what happened the desk top short works and opens LT ?

Dennis 

185

LazyTurn / Re: LazyTurn

« on: February 24, 2010, 07:00:38 PM »

Guy's i have updated Mach to the latest version and went to install the latest version of LT but now i can't find the green LT icon in the Mach folder to copy LT to why dose this happen aaaaah.

Dennis

186

LazyTurn / Re: LazyTurn

« on: February 24, 2010, 11:40:26 AM »

Art
Wow Thanks i have been waiting a very long time for turn thanks for getting it this far i will give it a whirl and see how it works.

Dennis

187

LazyTurn / Re: LazyTurn

« on: January 27, 2010, 10:50:40 AM »

Hi Art
i have been looking on the forum from time to time waiting for LT just download the test file and looking forward to working with it I'll let you know my finding's, yes not many lathe programs around all kinds of mill programs though funny thing though with so many turning centers what do they use? thanks for sticking with it.

Dennis

188

Third party software and hardware support forums. / Re: RhinoCam Mach3 Post Processors

« on: January 03, 2010, 12:35:23 PM »

Hello Hoop
 I would like a copy of the post processors when i clicked on your link it brought a web site called media fire and i couldn't find the post processor any where on the page thanks.

Dennis

189

General Mach Discussion / Re: New REV

« on: November 09, 2009, 08:35:14 PM »

Thanks Hood I will install that ver.

Dennis 

190

General Mach Discussion / Re: New REV

« on: November 09, 2009, 03:33:39 PM »

Hood it's under lock down version.

Dennis